Filter Your Search
Category Group
Brand
Shop by Category
Search Results
1/2-3/4 HOLE BRUSH NYLON - SMP ETB6
Use these brushes for cleaning drilled holes prior to adhesive anchor installation. Specifically designed for use with SET-3G™ adhesive to permit proper hole cleaning with fewer brush strokes at embedments up to 20 times the anchor diameter. T-handles, extensions and brushes are sold separately.
Features
- Brushes have a twisted wire handle with nylon bristles
- Easy-to-use
- Heavy-duty
- Sturdy and reusable
- For use with Simpson Strong-Tie® SET-XP®, AT-XP®, ET-HP®, AT and SET adhesives
HI-VIS APRON CHAPS - STL 7010-884-0828
HI-VIS APRON CHAPS PERFORMANCE HI-VIS APRON CHAPS 6 LAYER
RECTORSEAL 5, ONE PINT - REC 25431
Pipe Thread Sealant, 16 oz, Container Type Can, Color Yellow, Gas Pressure Range 2,600 psi, Liquid Pressure Range 12,000 psi, Full Cure Soft Set Pressure Test Immediately, Begins to Harden Not Specified, Application Temp. Range 20 Degrees to 140 Degrees F, Performance Temp. Range -50 Degrees to 400 Degrees F, Flash Point 150 Degrees F, Specific Gravity 1.38, Viscosity 40,000cp
OPEN REEL LONG TAPE 1/2" X 100' - STN 34-790
STANLEY® Fiberglass Open Reel Long Tape 1/2” x 100’
Features
- 1/2” wide blade with easy-to-read markings.
- 2-sided blade graphics with fractional inch/decimal foot scales.
- Polymer-coated blade withstands abrasion.
- High-impact ABS case with rubber grip holds up to heavy use
- Corrosion-resistant Tru-Zero™ folding end hook for accurate measurements.
Graduations
- Side One: Major scale in consecutive feet. Minor scale numbered in consecutive inches after each foot. Graduated in 8ths of an inch. Side Two: Major scale in consecutive feet. Minor scale numbered in consecutive 10ths of a foot repeated every foot. Graduated in 100ths of a foot.
#3-1-101 CUTTING TIP VICTOR - VIC 0330-0002
#3-1-101 CUTTING TIP VICTOR 0330-0002
DS 4-1/2X1/4X5/8-11 Z-TECH - SAI 22610
- SAIT Z-TECH™ – Z24R
- Tough zirconium grain
- High performance grinding for the toughest applications
- METAL Ferrous metals (iron, steel, welds, etc.)
- STAINLESS Stainless steel, high tensile alloys
