Accessories

ADAPTER 1/2” SQ TO 7/16” HEX

CARTRIDGE FILTER

With the ability to finely mix all kinds of material, this innovative ribbon design ensures an even mix and is ideal for a range of applications such as drywall mud, paint and EIFS adhesives, and coatings. Made from high quality plated steel, the MARSHALLTOWN Ribbon Mixer creates efficiency and consistently on the job working best at 500-900 RPM. The 2” and 3” fit a ?” or larger speed drill, and the 4” and 5” fit a ½” or larger speed drill. This design comes in many sizes.

Features

• High quality plated steel material
• 2” and 3” fit a ?” or larger speed drill
• 4” and 5” fit a ½” or larger speed drill
• Best working at speeds of 500-900 RPM

Canister vacuum filters fit compatible canister vacuums to stop dust and allergens from recirculating during vacuuming. They filter fine particles from the vacuumed air as it exits the vacuum’s exhaust port.

This Nilfisk Microfilter is like a white fabric bag, fitting over the bottom of the motor. It retains 99.5% of all particles to 2 ?m, cleaning the air quite well before it reaches the motor and final ULPA or HEPA filter. It should be replaced after you use ten paper bags to keep your Nilfisk performing well. Nilfisk has replaced this filter with their similar 117304-10 filter.

100# PRESSURE GAUGE

Apex 5/8’‘ Square Drive Adapter Description
Apex® 5/8’‘ female square drive to 1/2’‘ male square square drive adapters. Apex® Fastener Tools square drive adapters feature quality construction and a innovative design that ensures a long service life. With Apex® square drive adapters you are assured of high quality and industrial strength. Apex® square drive adapters have hex tolerances that are on average 48% tighter than DIN and 35% tighter than ANSI requirements. Square drive adapters from Apex® Fastener Tools are built so that you are assured of an exact, sure fit. All Apex® square drive adapters have the tightest tolerances for straightness and concentricity in the industry. High strength fasteners in demanding situations, like those found in the automotive and aviation industries, often require the use of an impact wrench or impact driver to deliver the amount of torque required to tighten or loosen them.

Features

• Part Number: MDA-14
• Size: 7/16”
• Overall Length: 2”
• Socket Nose Diameter: 11/16”
• Magnetic
• 1/4” Shank Diameter
• Made in USA
• Min order: 12

.45 LINER

Features

• 50’ range allows for faster installations with fewer pulls
• Bright yellow body reduces chances of leaving the CableCaster behind
• Aerodynamic darts are glow-in-the-dark
• Has pen-light flashlight mount

Applications

Wire pulling tool for lightweight communications cable in hard to reach areas