Search in Category
Sockets
Search term required.
Filter Your Search
Color/Finish
Drive Size
No Filtered Results...
Finish
Length Type
Maximum Opening
Measurement Type
No. of Points
Socket Size
No Filtered Results...
Subcategory
Shop by Category
Loading...
Sockets
Viewing Page 11 of 328
(3,277 results)
1/2INDR 10PC METRIC HEX - G/P 1498MH
Item #:
G/P 1498MH
Supplier Part #: 1498MH
Brand:
Grey Pneumatic
Grey Pneumatic 1498MH 1/2 inch Drive Metric Hex Driver Impact Socket Set
3/4DR 2IN GRB RR RINGS - PROT JRR07532
Item #:
PROT JRR07532
Supplier Part #: JRR07532
Brand:
PROTO
Features
- Retaining rings are used to help secure sockets onto drive tools.
- They are not intended to bear any load.
- The rotational forces are between the drive tool and the socket.
- The resin crush gauge on the pin helps indicate when a socket is excessively worn and should be replaced.
- Drive tool and socket should line up when in use and should not pinch the crush gauge.
- Cracked sockets and/or worn drive tools cause each other to turn excessively in relation to each other. This action pinches the small fin or the crush gauge on these retaining rings. If the crush gauge is pinched, it is an indication that the socket and or the drive tool need to be replaced.
- One-piece construction, no loose parts. Pin is made of resin which allows the material to compress without breaking.
- Part numbers are embossed on the rings near the point at which the pin and ring meet.
1 PC SOCKET RETAINERS - PROT JRR07526
Item #:
PROT JRR07526
Supplier Part #: JRR07526
Brand:
PROTO
Features
- Retaining rings are used to help secure sockets onto drive tools.
- They are not intended to bear any load.
- The rotational forces are between the drive tool and the socket.
- The resin crush gauge on the pin helps indicate when a socket is excessively worn and should be replaced.
- Drive tool and socket should line up when in use and should not pinch the crush gauge.
- Cracked sockets and/or worn drive tools cause each other to turn excessively in relation to each other. This action pinches the small fin or the crush gauge on these retaining rings. If the crush gauge is pinched, it is an indication that the socket and or the drive tool need to be replaced.
- One-piece construction, no loose parts. Pin is made of resin which allows the material to compress without breaking.
- Part numbers are embossed on the rings near the point at which the pin and ring meet.
